GROUNDED PLUG
To reduce the risk of electric shock this appliance has a grounded plug (2 blades
and 1 pin). If the plug does not fi t fully into the electrical outlet contact a qualifi ed
electrician. Do not modify the plug in any way or use an adaptor.
BEFORE FIRST USE
1. Read the instructions.
2. Remove all packing material and stickers. Do not remove the rating label.
3. Clean the baking surface by wiping with a damp cloth.
4. Season the baking surface by wiping with a paper towel moistened in a small
amount of vegetable oil. This needs to be done only the fi rst time that the crepe
maker is used.
5. Discard the fi rst crepe.
HOW TO USE
In all crepe batters, the proportions of fl our, eggs and liquid can be varied to produce
a thin, lacy crepe, a sturdier thicker crepe or an egg-y rich crepe. Adding butter
or margarine adds fl avour and makes removal from the pan easier. Oil may make
crepes stick slightly. Sugar adds crispness but may make crepes break in rolling.
Since dessert crepes have a sweetened fi lling and/or sauce, you can use a basic
batter without sugar for crepes you wish to fold or roll.
Making the fi rst few crepes takes a little practice. After the fi rst few you will
master the art of crepe making.
1. Place the power base on a dry level surface.
2. Place the Crepe Maker on the power base and plug into the wall outlet.
3.
Switch to the ‘ON’ position.
Warning:
Do not touch the baking plate. Appliance is getting hot!
4.
After a few minutes, the indicator light will turn on. Now the Crepe Maker is
hot and you can start baking.
5. Pour the crepe batter into the batter dish.
6.
Remove the Crepe Maker from the power base. Turn the Crepe Maker so that
the baking surface faces downward.
7.
Hold the baking surface of the Crepe Maker into the batter dish for 3 seconds.
NOTE:
Do not immerse the appliance too deep in the batter.
8.
Move the Crepe Maker back and forth so that the complete baking surface is
covered by batter.
NOTE:
Do not hold the Crepe Maker in the batter for more
than 3 seconds. If the Crepe Maker is held too long in the tray, the crepe will
not stick to the baking surface.
9. Place the Crepe Maker back onto the power base.
10. The crepe is ready when the indicator light comes on or when the crepe has
reached the desired browning degree and steam is no longer visible.
11. Remove the Crepe Maker from the power base again and turn the Crepe
Maker over a plate so that the crepe falls off onto the plate. If it sticks, loosen
carefully at the edge with a plastic or wooden utensil. NOTE: It is not required
to brown the other side of the crepe.
12. For additional crepes follow the instructions above.
4
CM1337_CrepeMakerBooklet_E.indd 4
CM1337_CrepeMakerBooklet_E.indd 4
13-07-03 4:30 PM
13-07-03 4:30 PM
Summary of Contents for CM1337
Page 1: ...Instruction Booklet Model CM1337 crepe tortilla maker ...
Page 19: ......