CARE AND CLEANING
1. Allow the Corn Popper to cool.
2. Wash the Cover and Plastic Cap in hot soapy water. Rinse and dry. Do
not use scouring pads or abrasive powder on the cover as these could
scratch the plastic.
3. Remove the Stirring Rod from the Base by turning the Center Knob
counter clockwise and lifting up the Stirring Rod near the center of the
Rod. Wash the Stirring Rod and Knob in hot soapy water. Rinse and dry
thoroughly. NOTE: Be careful not to bend the Stirring Rod. Only remove
or replace the Stirring Rod at the center of the Rod. DO NOT pull on the
ends of the Rod.
4. Clean the non-stick surface of the base with a damp soapy cloth, sponge
or nylon scouring pad that is safe for non-stick surfaces. Do not use
abrasive scouring pads or powders. NOTE: Do not let water or any liquid
accumulate on the Popping Surface as it will enter the base of the unit
under the Center Knob and damage the Corn Popper.
5. After consistent use, the non-stick finish may discolour. This will not affect
the performance of the Popcorn Maker. To remove the discolouration use a
soft cloth saturated with lemon juice or vinegar and rub over the finish.
Wipe with a clean damp cloth and dry.
NOTE: Do not place the Cover, Plastic Cap, Stirring Rod, Base or Cord in the
dishwasher.
5
Booklet_TCP-615R_EN:TCP-6L Booklet_VHR 3/8/10 12:26 PM Page 5
