6. REMOVE the Plastic Cap.
7.
If buttered popcorn is desired, divide recommended amount of
refrigerated butter into 6 equal-sized pieces and place in a single
layer over the holes in the Butter Well. If unrefrigerated butter
is used, add to Butter Well after the fi rst corn kernel pops. If
unbuttered popcorn is desired, do not add butter to the Butter
Well.
IMPORTANT:
NEVER leave the Plastic Cap on when making
popcorn. Put the Plastic Cap on AFTER popping is complete and
before fl ipping popcorn into the Cover.
8. Plug into a 120 volt AC wall outlet only.
9.
Press the ON/OFF Switch to the ON (I) position. The stirring rod
will rotate as long as the Popcorn Maker is on. Do not shake the
Popcorn Maker during the popping cycle. The popping cycle will
take approximately 4 – 6 minutes. When there is a 1 – 2 second
pause between pops or if the popped kernels are lifting the Cover off
the base then the popping cycle is complete.
10. To avoid scorching, immediately switch the ON/OFF Switch to the
OFF position. Snap the Plastic Cap securely onto the Butter Well,
grasp handles of Popping Plate and Cover together, lifting them off
of the base. Quickly fl ip upside down and lift the Popping Plate away
from the Cover, lifting away from you to avoid any escaping steam.
11. Place the hot Popping Plate on a wire rack or back onto the Base.
12. Unplug the Popcorn Maker from the wall outlet.
13. Popcorn is ready to serve. If desired, sprinkle salt or seasonings
over the popcorn.
14. If additional batches of popcorn are desired transfer popcorn in
another serving bowl and follow steps above.
CARE AND CLEANING
1. Clean the Popcorn Maker after each use.
2. Allow the Popcorn Maker to cool before cleaning
3. Wash the Cover, Plastic Cap and Popping Plate in hot soapy water.
Rinse and dry. Do not use scouring pads or abrasive cleansers on
the Cover or Popping Plate as these could scratch the surface. The
Cover and Popping Plate can also be placed in the dishwasher. The
Cover should be placed on the top rack only.
4. Be careful not to bend the Stirring Rod when washing.
5. Clean the Base by wiping with a damp cloth or sponge. DO NOT
remove the grate from the Base for cleaning. NEVER immerse the
Base in water or any other liquid.
6. After consistent use, the non-stick fi nish on the Popping Plate may
discolour. This will not affect the performance of the Popcorn Maker.
To remove the discolouration use a soft cloth saturated with lemon
juice or vinegar and rub over the fi nish. Wipe with a clean damp cloth
and dry.
5
Salton_CP1356Y_InstructionBooklet_E.indd 5
Salton_CP1356Y_InstructionBooklet_E.indd 5
13-09-26 11:13 AM
13-09-26 11:13 AM
