10. If the kettle is accidently switched on when empty, the thermostat will
automatically shut off the kettle to prevent it from overheating. Unplug
the power base and let the kettle cool before refilling.
NOTE:
The display screen works independently from the kettle. Once the
thermostat is shut off, the display screen on the power base will continue
to function until the selected temperature is reached. The unit will beep
indicating the unit (without water) has reached the selected temperature.
This is normal.
11. The power base must be turned off once the water has reached the
selected temperature (hold the On/Off button for 3 seconds) and the
power cord be disconnected from the wall outlet when not in use.
DO NOT
attempt to connect any other appliance to the Power Base or
tamper with the connector in any way.
IMPORTANT:
If the power base is not turned off immediately after use,
the kettle will continue to display the current temperature of the water.
DO NOT
leave kettle unattended and remember to shut off the base
when finished using.
Keep Warm/Manual temperature selection
You can manually select the desired temperature by selecting the pre-
programmed setting of 70ºC and then pressing either the + or - buttons to
increase or decrease the temperature between 50ºC to 95ºC by increments of
5ºC.
While using this setting, the kettle will ‘Keep Warm’ the selected temperature
for 2 hours. During this time the On/Off light will remain illuminated and the
kettle will cycle on an off in order to keep the current temperature chosen.
After 2 hours the kettle will switch off automatically and the red light on the
On/Off button will go off.
After the kettle has switched off remember to press and hold the On/Off
button for 3 seconds to turn off the Power Base and unplug from the wall
outlet.
5
Booklet_JK1277_ENG_Salton Booklet 4/20/11 10:45 AM Page 5
