background image

 

15.

 

Do not allow the cord to touch hot surfaces and do not place on or near a hot gas or 

electric burner or in a heated oven. 

16.

 

Do not use the appliance on a gas or electric cooking top or over or near an open flame. 

17.

 

Use of an extension cord with this appliance is not recommended. However, if it is 

necessary to use an extension lead, ensure that the lead is suited to the power 

consumption of the appliance to avoid overheating of the extension cord, appliance or 

plug point. Do not place the extension cord in a position where it can be pulled on by 

children or animals or tripped over. 

18.

 

This appliance is not suitable for outdoor use. Do not use this appliance for anything 

other than its intended use. 

19.

 

Never carry the appliance by the power cord. 

20.

 

Do not leave this appliance unattended during use. Always unplug when the mixer is not 

in use or before cleaning. 

21.

 

Always operate the appliance on a smooth, even, stable surface. 

22.

 

Turn the mixer on only after the beaters or dough hooks have been inserted. Always wait 

until the beaters/dough hooks have stopped completely before removing them from the 

mixer. 

23.

 

Keep hands and other utensils out of the bowl while mixing to reduce the risk of severe 

injury to persons or damage to the machine. 

24.

 

Do not mix/blend hot liquids. 

25.

 

Ensure that the switch is in the “Off” position after each use. 

26.

 

Use this mixer only with the stand provided. 

27.

 

To avoid overheating of the motor, do not use speeds 1 or 2 when using the dough hook 

attachments. 

28.

 

Do not use the dough hooks in stand mixer mode. 

29.

 

To avoid the danger of fire and/or explosion, do not use this mixer to stir paints or 

solvents. 

30.

 

The manufacturer does not accept responsibility for any damage or injury caused by 

improper or incorrect use, or for repairs carried out by unauthorised personnel. 

31.

 

In case of technical problems, switch off the machine and do not attempt to repair it 

yourself. Return the appliance to an authorised service facility for examination, 

adjustment or repair. Always insist on the use of original spare parts. Failure to comply 

with the above mentioned pre-cautions and instructions, could affect the safe operation of 

this machine. 

Summary of Contents for SSBM07











Reviews: