Tel: 886.2.2175 2930 Email: sales@salukitec.com
www.salukitec.com
104
Section 3 Description of Interference Analyzer Menu
1
Frequency menu
Center Freq
Freq
Span
Start Freq
Stop Freq
Step Freq
Auto
Man
Signal Std
--
Channel
--
>
>
·
[Center frequency]: Press [Frequency]→[Center Freq], and set it with number
keys on the front panel. Select [GHz], [MHz], [kHz] or [Hz] in the frequency unit
menu or set the center frequency with the [↑] or [↓] key or knob.
· [Special note]: When the [↑] or [↓] key or knob is applied, the frequency
step should be the same as the set value of [Step Freq]. You can set the step
frequency with the number keys or [↑] or [↓] key or knob after changing [CF
Step Auto Man] into [CF Step Auto Man].
· [Span]: Press →[Span] to activate the span menu. Set the span with the number
keys, and select the frequency unit, or set the span with the [↑] or [↓] key or knob.
Refer to [Span] menu description for details.
· [Special note]: When the span is changed with the [↑] or [↓] key or knob, the
step should be 1-2-5 (the RSSI mode must be set under zero span).
· [Starting frequency]: Press [Frequency]→[Start Freq], and set it with number
keys on the front panel. Select the frequency unit, or set the value with the [↑] or [↓]
key or knob.
· [Stop frequency]: Press [Frequency]→[Stop Freq], and set it with number keys
on the front panel. Select the frequency unit, or set the value with the [↑] or [↓] key
or knob.
· [Signal standard]: Press [Frequency]→[Signal Std] and select the signal
standard with the [↑] or [↓] key or knob, recall the signal standard by [Done] or [OK]
in the dialog box. Refer to the dialog box for details.
· [Special note]: When the signal standard is applied, the center frequency
and span will be set as those defined in the signal standard.
· [Channel No.]: Press [frequency]→[Channel], and the channel setting dialog box
will pop up. Set the channel with the number keys or [↑] or [↓] key or knob.
· [Special note]: The channel should be set based on the applied signal
standard; otherwise, the prompt that setting is not allowed will pop up.
