Tel: 886. 909 602 109 Email: sales@salukitec.com
www.salukitec.com
49
After changing the settings, you need to click
to finish this configuration. Otherwise the
settings are void.
4. Reference and Frequency Sweep Configuration
The configuration area of reference signal is shown in the red box in Fig.41. The details of configuration are shown in
Table 4.
Fig.41 The Configuration Area of Reference Signal
Table 4. Reference Signal Configuration
PHASE
-180° to +180° by one step of 0.01°
Reference Source
External
Internal
External Ref Trigger
TTL Rising Edge
Sine Zero Crossing
Int. Frequency
Manually, 1mHz to 120kHz by one-step of 1mHz at least.
Note that:
After finishing all the settings, click the button
to finish the configuration for input signal.
All settings can be changed at the same time and you just need to click the button once.
After changing the settings, you need to click
to finish this configuration. Otherwise, the
settings are void.