STB8827
Series Operation Manual Chapter 3 Introduction to [MEAS]
12
Primary parameter
|Z| (Module of impedance)
|Y| (Module of admittance)
L (Inductance)
C (Capacitance)
R (Resistance)
G (Conductance)
DCR (DC resistance)
L2A (Primary inductance)
L2B (Secondary inductance)
Secondary Parameter
D (Dissipation factor)
Q (Quality factor)
R
s
(Equivalent Series Resistance ESR)
R
p
(Equivalent Parallel Resistance)
X (Reactance)
B (Susceptance)
θ
(Phase Angle)
N, 1/N (Turn ratio and polarity)
M (Mutual inductance)
R2 (DC resistance)
Test results of primary and secondary parameters are respectively displayed in
two lines in the form of upper-case characters. The primary parameter displays in
the upper line while the secondary parameter displays in the lower line.
Operation steps for setting test function:
1) Move the cursor to FUNCA zone, the following soft keys will be displayed on
the screen.
C
p
—…
→
C
s
—…
→
L
p
—…
→
L
s
—…
→
↓
2) Press the soft key corresponding to C
p
—…
→
, the following parameters will be
shown for your choice.
C
p
-D
C
p
-Q
C
p
-G
C
p
-R
p
←
Press the soft key corresponding to your desired parameter. Then press
←
to
return to upper soft key menu.