STB8827
Series Operation Manual Chapter 3 Introduction to [MEAS]
21
STB8827
303
The following control parameters can be set on the <
BIN COUNT
> page.
Count function ON/OFF (
COUNT
)
There are 2 zones are displayed in this page:
BIN COUNT DISP
,
COUNT
. The
function of each zone will be introduced as below.
The following test result/ condition can be displayed in this page but cannot be set
in this page. Users can set them on the
<LIMIT TABLE SETUP>
page.
Test parameter (PARAM)
Nominal value (NOM)
Bin limit value (HIGH/ LOW)
3.3.1 PARAM
Parameter zone shows the “Function” parameter, if user selects primary and
secondary parameter swap compare mode, the parameter will be displayed as
swap parameter, such as: “Cp-D” is displayed as “D-Cp”, which means the current
D is compared as primary parameter while Cp is compared as secondary
parameter.
3.3.2 NOM.
Nominal parameter is the nominal value used to make bin compare.
3.3.3 BIN
This zone shows the bin number of the limit list. “2nd” means the secondary
parameter limit.
