STB8827
Series Operation Manual Chapter 4 [SYSTEM] and [FILE MANAGE]
49
REF B
Control and set parameters on <BIN COUNT DISP> page
BIN COUNT (ON/OFF)
Control and set parameter on <LIMIT TAABLE SETUP> page
PARAM (swap parameter)
NOM (reference value)
MODE (%-TOL/ABS-TOL/SEQ-MODE)
AUX (ON/OFF)
COM (ON/OFF)
High and low limits of each bin
Control and set parameters on <List Sweep Setup> page
List Sweep Mode (SEQ/STEP)
List Sweep Parameter (Frequency/Level/Bias)
Test points of all sweep parameters
High and low limits of all test points, including limit parameters
(LIMIT-DATA A/LIMIT-DATA B)
Page format currently displayed
4.2.2 U-disk manage performance
As described above,
STB8827
has a standard configuration of USB HOST interface,
so the external U-disk can be used as the memory media. In this condition, it
breaks the memory limit of 40 groups of *.LCR files. Meanwhile those files can be
copied to IBM PC or compatible desk-top computer, laptop with USB interface to
reach the infinite extension.
STB8827
supports the USB memory devices as below:
Meet the USB 1.0/1.1 standard
Capacity: 32MB/256MB/2GB/4GB
File format: FAT16, FAT32 (Format the USB memory on Microsoft Windows
operation system)
4.2.3 Operation steps for file management
A. Search an existed file
1) Roll the knob to view one by one.
2) Use the [
←
] and [
→
] to view one page by one page.
3) Press the soft key
FIND
. Input the file character and then press the
[ENTER] to search the target file.
4) Input the page number and press the [ENTER] to search the file.
B. Save the following control and setting parameters to a file by the
following steps
1) Select and set all control and setting parameters on the desired page.
2) Move the cursor to
FILE MANAGE
, the following soft keys will be displayed.