ENGLISH
5.5 Application 4-20mA bar
TRANSDUCER
10 bar
TRANSDUCER
10 bar
TRANSDUCER
16 bar
IT IS USED TO SET THE FULL
SCALE OF THE TRANSDUCER
USED
START PRESSURE
2.5 bar
START PRESSURE
2.5 bar
IT IS USED TO SET THE
PRESSURE REQUIRED TO
START THE MOTOR
START DELAY
OFF
START DELAY
OFF
IT IS USED TO SET THE DELAY
FOR STARTING THE MOTOR WHEN
THE SYSTEM PRESSURE
DROPS BELOW THE
START PRESSURE
RANGE 1min ÷ 99h 59min
STOP PRESSURE
3.0 bar
STOP PRESSURE
3.0 bar
IT IS USED TO SET THE
NECESSARY PRESSURE
ABOVE WHICH
THE MOTOR STOPS
TRANSDUCER
25 bar
OFF
EXCLUDES THE START DELAY
START DELAY
0h 2 min
MINIMUM PRESSURE
OFF
MINIMUM PRESSURE
OFF
IT IS USED TO SET THE REQUIRED
PRESSURE BELOW WHICH THE
MOTOR STOPPED. AT THE MOTOR
STARTING THIS PARAMETER IS
BYPASSED FOR 1 MINUTE
MINIMUM PRESSURE
0.5 bar
OFF
EXCLUDES THE
MINIMUM PRESSURE
TRANSDUCER 10bar: 0.1 ÷ 7.9bar
TRANSDUCER 16bar: 0.1 ÷ 13.9bar
TRANSDUCER 25bar: 0.1 ÷ 22.9bar
TRANSDUCER 10bar: 0.2 ÷ 8bar
TRANSDUCER 16bar: 0.2 ÷ 14bar
TRANSDUCER 25bar: 0.2 ÷ 23bar
TRANSDUCER 10bar: 0.1 ÷ 7.8bar
TRANSDUCER 16bar: 0.1 ÷ 13.8bar
TRANSDUCER 25bar: 0.1 ÷ 22.8bar
5. PROGRAMMING
12
5.1
31
PROBES SENSITIV.
1Okohm
IT IS USED TO SET
MANUALLY THE PROBES
SENSITIVITY VALUE
RANGE 0 ÷ 100kohm
PROBES SENSITIV.
1Okohm
BY PRESSING IT YOU RETURN
TO THE FIRST SETUP SCREEN;
SEE CHAPTER 5.7
PRESSING IT FOR MORE THAN
1s YOU GO OUT OF THE SETUP
AND THE PARAMETERS ARE
STORED IN THE MEMORY
Summary of Contents for MULTIPLUS 1 SA684 Series
Page 24: ......
