SALUPO MULTIPLUS 1 SA684 Series, Instruction And Installation Manual

ENGLISH

6. GENERAL FUNCTIONING OF THE CONTROL PANEL

6.1 

General functioning

 SETUP   PREMI

PAG   +   MAN      10s

ON

THIS SCREEN IS DISPLAYED ONLY IF THE MAINS

SUPPLY WAITING FUNCTION IS ENABLED

IN THE SETUP MENU. TO EXCLUDE THE

WAITING TIME PRESS 

RESET

400 V                                        13.2A

Cf    0.80                                    0 h

MAINS     WAIT.          1 m

RESET     TO     START

THE OPERATION SCREENS RELATING TO THE CHOSEN
APPLICATION ARE DISPLAYED BELOW
COS

φ

 = SEE CHAPTER 6.2 

CLEAN WATER = SEE CHAPTER 6.3
SEWAGE = SEE CHAPTER 6.4
4-20mA bar = SEE CHAPTER 6.5
4-20mA meters = SEE CHAPTER 6.6

}

6.2 Application cos

φ

THE FOLLOWING SCREEN DISPLAYS:
- MEASURED VOLTAGE
- ABSORBED CURRENT
- COS

φ

 DETECTED

- OPERATING HOURS OF THE MOTOR 

AUTOMATIC      MOTOR

Cf     0.80                          13.2 A

STOP     MOTOR

Cf     1.00                0.0 A

400 V                                   13.2 A

Cf     0.80                                    0h

IT IS USED TO START

THE MOTOR MANUALLY 

EXTERNAL   COMMAND

OFF

EXTERNAL   COMMAND

ON

OFF: DISABLE MOTOR
ON: ENABLE MOTOR

6.1

IF THE MOTHERBOARD DETECTS A

DRY RUNNING CONDITION IT WILL

BE POSSIBLE TO DISPLAY A FOURTH SCREEN 

WAITING    FILLING

START       1 h      10 m

IT DISPLAYS THE REMAINING

WAITING FILLING TIME

It is used to scroll through the pages

Pressed in MOTOR STOP status it starts the motor
in manual mode

Pressed it starts the motor in automatic mode

Pressed the motor goes in STOP function
Pressed in case of an alarm it resets it

35

IGNITION

CONTROL PANEL

ONLY IN STABLE MANUAL

BUTTON MODE