Pairing for radiator system without Internet connection
The pre fix number on the ARV will
change as the ARV(s) pair.
Once all ARV’s have paired press
If you use the maximum number of
ARVs it will automatically take you to
the Mainscreen.
5 sec
5 sec
Setting the time (for systems without internet only)
3 Sec
Use right and left to select
the day of the programs.
Use right and left to select
the day of the programs.
Set the program / schedule (for systems without internet only)
5/2
Individual
7 Days
Installation – Check the paired devices
If you want to see what devices are connected to your Universal Gateway you can
know exactly by using the Identify procedure.
Tap the tile from
the Dashboard.
Tap the name
of your device.
Factory reset
If you have made an error or need to change your system parameters please follow
steps below. This should only be done by your installer.
Now you are ready to
set up your system
as desired.
Press all three buttons
simultaneously
Wait until the LED is
solid red. Press the Open/
Close button once. When
the initialization process is
complete, the LED
will go off.
Press and hold the
for 10 seconds until the ARV
starts flashing red
.
If the pre-configured program is not suitable for your application, hold down the
bottom three keys for a short time, until the display shows SEL PROG. Do these
settings before adding the thermostat to the universal gateway.
Installation – System Parameters
Use or to select the type of unit.
After selection has been made, press to confirm.
Programmable Thermostat
Digital Thermostat
Hot water timer
Selecting unit type
Tap the Identify
button. Your device
will start flashing
Tap the button again
after identifying your
device.
OR
5 sec
OR
5 sec
5 sec
2
4
1
3
Pairing for underfloor system without Internet connection
5 sec
7
1
2
3
4
5
6
7
8
5
6
9
On step 6 please select your zone number by using the UP or DOWN arrows.
