25
3 sec.
3 sec.
6. Installer parameters
To enter installer parameters please follow steps below. Please refer to parameters table description before any changes. Use
or
buttons to move
up or down between all parameters. Every change/selection confirm by button:
1
3
Use
or
to choose
code „49”.
Press button to confirm.
Select installer parameter by or
buttons. Use
or
buttons to
change parameter value.
Confirm choice by button.
4
2
Hold + buttons for 3 seconds
to enter the installer mode.
dXX
Function
Parameter
Values
Description
Default
Values
d01
Heating Control
This parameter defines the algorithm of the room temperature control.
0
PWM (Pulse-width modulation) algorithm ensures reduction of overdrive
states and economic operation of the system. It is an advanced algorithm
designed to precisely maintain room temperature.
0
1
SPAN ± 0.25°C (± 0.5°F)
2
SPAN ± 0.5°C (± 1.0°F)
d02
Room temp. offset
-3.0°C to
+ 3.0°C
Offset room temperature measuring is a function which allows user to
recalibrate internal thermostat’s temperature sensor by a given number of
degrees (in the range from -3,0 °C to 3,0 °C in 0,5°C steps).
0.0°C
d03
OUT sensor probe (S1/S2)
0
Out sensor probe not connected
0
1
Out sensor probe connected
d04
Air sensor or Floor sensor
0
Air sensor: If parameter d03 is inactive (d03 = 0) then internal sensor
controls the temperature
Air sensor: If parameter d03 is active (d03 = 1) then internal sensor is
disabled and OUT sensor controls the temperature
0
1
Floor sensor: If parameter d03 is inactive (d03 = 0) then internal sensor
controls the temperature
Floor sensor: If parameter d03 is active (d03 = 1) then internal sensor is
disabled and OUT sensor controls the floor protection temperature
3
Summary of Contents for BTRP230V
Page 1: ...BTRP230V 50 THERMOSTAT FULL USER MANUAL...
Page 2: ......
