49
7. Installation in OFFLINE MODE without SALUS SmartHome application
7.1 General informations
In OFFLINE mode
(without application), you can use the
UGE600 Universal Gateway
or
CO10RF coordinator
to configure the system. Please note
that you cannot use both devices at the same time. Before installing the system you have to decide:
- to create a network using the
UGE600 Universal Gateway
(you can connect it to the Internet in the future)
- to create a network using the
CO10RF coordinator
(you can’t connect it to the Internet)
REMEMBER!
The
UGE600 Universal Gateway
and
CO10RF coordinator
are two different devices.
Each device creates and operates it’s own network.
Universal Gateway -
- CO10RF Coordinator
Please note!
If your system has been installed in the OFFLINE mode using the
UGE600 Universal Gateway
and then connected to the Internet,
all devices should be found in the SALUS Smart Home application (using „Scan for equipment” button). All devices found in the application don’t
need to be reconfigured, because all settings are automatically copied from the gateway.
Please note!
If your system was created using the
CO10RF coordinator
and you would like to control the devices via the Internet, then all
devices should be reinstalled using the UGE600 Universal Gateway.
CO10RF Coordinator
You can use standard ZigBee network coordinator to install and use your
devices.
NOTE:
CO10RF Coordinator is included in the set with the KL08RF
Control Box.
Universal Gateway is
NOT CONNECTED TO THE INTERNET
You can use your devices locally without the Smart Home App. Gateway
works in this mode as standard ZigBee coordinator.
KL08RF
- Wiring Centre for 8-zone
underfloor heating (UFH).
+ extension KL04RF
TRV
(Thermostatic Radiator Valve)
-
with wireless communication.
RX10RF
receiver
Summary of Contents for HTRP-RF(50)
Page 1: ...HTRP RF 50 THERMOSTAT FULL USER MANUAL...
Page 4: ......
