58
7.4 Pairing with RX10RF receiver
5
6
Confirm choice by button.
Use
or
buttons to:
- choose pairing with the RX10RF receiver in
the „RX1” configuration, if the receiver is set as
RX1 (receiver responds to the heating signal
from any thermostat),
- choose pairing with the RX10RF receiver in
the „RX2” configuration, if the receiver is set as
RX2 (receiver responds to the heating signal
only from one thermostat).
Confirm by button
PLEASE NOTE!
For easier installation, please make sure you have already added RX10RF receiver to your ZigBee network (please refer to the RX10RF receiver manual
instruction).
2
3
Now thermostat is looking for the
signal from the coordinator...
4
Open the ZigBee network.
OR
5 sec.
5 sec.
8
Close the ZigBee network.
OR
3
3
5 sec.
5 sec.
7
When thermostat is succesfully
paired main screen will be
displayed.
1
Hold + buttons for 3 seconds
to launch the extended
configuration.
3 sec.
3 sec.
Extended configuration includes:
Underfloor heating
Thermostatic radiator valve (radiator heating)
RX10RF in RX1 mode
RX10RF in RX2 mode
The thermostat has been added to the ZigBee
network and paired with the gateway/
coordinator. Press button to confirm.
Summary of Contents for HTRP-RF(50)
Page 1: ...HTRP RF 50 THERMOSTAT FULL USER MANUAL...
Page 4: ......
