17
Connect the receiver to a 230V power supply (see its manual).
Press and hold the button. After 5 seconds, the red LED will
flash, which means the SR868 relay is ready to pair with the
thermostat.
5 sek.
.
Connect the plug to a 230V power supply (see its manual).
Press and hold the button. After 5 seconds, the red LED will
flash, which means the SPE868 plug is ready to pair
with the thermostat.
SPE868 PLUG
SR868 RELAY
RXRT510 RECEIVER
RXRT510 RECEIVER
RXRT510 RECEIVER
If you want to re-pair the devices with
each other, make sure that the receiver
is disconnected from the power supply
and the switches on it are in the AUTO
and ON positions. Then connect the
receiver to the power supply and wait
for the red diode to glow continuously.
Move the top switch to the OFF
position with a quick motion and
back to the ON position.
The red LED will start blinking, which
will confirm that the receiver has
entered the pairing mode.
A
B
C
8. RT310TX thermostat pairing with few other receivers
The word PAIRING in the user settings means the function of synchronizing the transmitter with the receiver again, if it has been removed.
REMEMBER! If the thermostat is already paired with any receiver, you will have to pair it again with
other receivers. You can pair few receivers with 1 thermostat RTRX510, SPE868 and SR868.
FIRST, PREPARE ALL THE RECEIVERS YOU WANT TO PAIR WITH THE THERMOSTAT.
THE PREPARATION OF THE RECEIVERS FOR THE PAIRING PROCESS IS CONFIRMATION OF THE RED LED FLASHING ON THEM.
1
TEST / PAIRING
TEST / PAIRING
3 sec
Press and hold TEST / PAIRING
button for 3 seconds.
Thermostat started pairing process. It can take up to
9 minutes.
Attention!
Forcing the pairing process
will generate a new communication code. All
receivers previously paired with the thermostat will
be irretrievably deleted from its memory.
2
3
