REVIEWING SET POINT TEMPERATURE
You can view the set point temperature
at any time by pressing either the UP or
DOWN key.
When any programme is running, the
LCD display will show the programme set
point temperature with the SET indicator
displayed:
When operating in Frost Protection
mode, the LCD display will show a
reading of 5 °C and also display the Frost
Protection indicator:
When operating in Temporary Override
mode, the LCD display will show the
temporary set point temperature:
To exit from the set point review, press any key except the UP or DOWN
keys, or don’t press any keys for approximately four seconds – either of
these actions will return the RT505TX to
Normal
mode.
TEMPORARY OVERRIDE
It is possible to temporarily override the current set temperature of the
RT505TX. There are two ways to do this:
•
While reviewing set point temperature: Pressing the UP or DOWN key
while reviewing the set point temperature will increase or decrease
the set point temperature in 0.5 °C steps.
•
In Normal mode: press and hold either the UP or DOWN key to display
the set point temperature. After two seconds, the RT505TX will enter
Temporary Override mode and allow increase or decrease of the set
point temperature. If the key is released within two seconds then you
will only be able to review the set point temperature.
RT505TX INSTRUCTION MANUAL
11
Salus RT505TX Manual Blue_89 12/03/2014 10:42 Page 11
