8-5
Section 8
SC102ZB/ST103ZB Installation and Operation Manual
Thermostat Configuration
Table 8.2: Special Function Codes (continued)
Join/Leave Network
– Press
SELECT
to join or leave a network .
Unpair from Remote
- Press
SELECT
Press to initiate unpairing with
ST103ZB while remaining on the network .
If the thermostat has not joined a network,
the display will enter the pairing sequence .
Follow the steps under Pairing in Section 3 .
If the thermostat is paired with a network,
UnPAir is displayed with “ ” flashing . Press
the or key to change the flashing letter
to “ ” . Press
SELECT
to remove the thermo-
stat from the network .
Factory Reset
- Press
SELECT
to initiate a factory reset.
SC102ZB Fan Coil Controller Only
UnPAir is displayed with “ ” flashing . Press
the or key to change the flashing letter
to “ ” .
Press
SELECT
to disconnect from the
ST103ZB Fan Coil Remote .
is displayed with a flashing “ ” .
Use the or key to change the flash-
ing letter to “ ” . Press
SELECT
to reset the
thermostat to all of the factory default
settings .