Installation instructions
10 / 28
3.3.7
Installing the compensation frame for Type 2011/2021 (option)
The compensation frame is required in order to com
pensate for the unevenness of the ground and to
ensure parallel entry into the cooking chamber.
Up to approx. 25 mm unevenness of the ground can
be compensated.
Kit compensating frame Item No. 881895: Suitable
for 881718 plate rack trolley, 880625 GN rack trolley,
879482 BN rack trolley.
Installing compensating frame
.
Use the screw feet and align the appliance hori
zontally
1. Remove the Allen screws from the clamps.
2. Push the clamps downwards over the retaining
tube.
3. Compensation frame not placed beneath the ap
pliance.
4. Push the clamps upwards over the retaining tube.
5. Use an Allen screw to fully tighten the clamps.
6. Horizontally align the compensation frame with
hexagon-headed bolts and lock using hexagon
nuts.
.
Check to make sure that the rack trolley can be
moved in parallel to the edge of the cooking
chamber.
3.3.8
Apply the safety sticker ”Max. shelf level for liquid cooking products”
D
WARNING!
Scald hazard!
Containers
with liquids or products to be boiled, becoming
liquid during the cooking process, may only be
pushed into the slot that can be easily viewed by
the operating personnel.
D
Slopping may cause scalding when removing li
quid cooked products!
D
For appliance where the top slot for containers is
placed higher than 1.60 m / 63 inches, the sticker
”Max. shelf level for containers with liquid” must
be affixed.
.
Affix the sticker at a level of 1.60 m / 63 inches.
Clean the area where the sticker will be affixed
before applying t.
Clamp, left
Clamp,
right
Retaining tube
Square tube
Square tube
1./5.
1./5.
2.
2.
3.
4.
4.
5.
5.
Summary of Contents for Cucina Evo Easy Series
Page 27: ...27 28 ...
