Installation instructions
15 / 28
5.
Connecting water drainage – connection examples
The water drain of gas appliances is centred under the appliance, see figure on next page 25 Chapter 9.2!
D
It is preferable to use the 1st or 2nd connection
examples. Other connection examples may
cause problems in case of backup in the waste
water system. The manufacturer does not as
sume any liability in case of direct connection to
the waste water system (e.g. 3rd and 4th wall
connection).
D
The waste water system must be designed ac
cording to DIN 1986-100 and DIN EN 12056-1.
D
Use steam temperature-resistant and flame-retar
dant drain pipe (HT pipe).
D
Do not reduce the pipe diameter.
D
The diameter of the on-site drainage pipe must
be at least 50 mm.
D
Do not place open drain funnel and water drain in
substructures or under the unit! Condensate may
form from escaping steam! Escaping steam must
be able to move away unhindered and must not
be able to enter electric appliances!
D
The manufacturer does not assume any liability
for consequential damages due to incorrect con
nection!
D
The slope from the appliance to the waste water
connection must be at least 10%!
.
To prevent water pouches from forming in waste
water pipes routed freely of extended distances,
the waste water pipe should be fastened at
shorter distances.
.
Fill the siphon with water.
Vent pipe protruding
above top of device
At least 25
cm/10 inch
3. Wall connection with on-site siphon and vent pipe
We recommend installing a vent pipe when fitting with an
automatic cleaning system and direct connection.
Installation example - appliance on base unit: Customer-
provided siphon in base unit and ventilation beyond the top
edge of the appliance.
4. Wall mount (not approved in Switzerland)
Attention!
This design may cause backup in
the drain and thus spilling over at the emer
gency overflow! With this type of connection
the manufacturer does not assume any lia
bility in the event of a fault (cause of the
fault is customer-related).
Get authorized Customer Service to install
an odour trap in the appliance: Locate and
attach the hose from the drip plate to the
appliance siphon so that it creates an odour
trap.
On-site siphon
Appliance
rear
Appliance
rear
≥ 50 mm
≥ 50 mm
On-site siphon
Appliance
rear
1.Siphon with drain funnel
Open drain funnel
At least 2 cm/1 inch
Appliance
rear
2.Floor drain with siphon
Recommended for models 2011, 2021 and double
rack designs QT.
≥ 50 mm
Summary of Contents for Cucina Evo Easy Series
Page 27: ...27 28 ...
