Installation instructions
17 / 28
7.
Initial commissioning
.
Remove cartons, foils, accessories, grilles and containers from the cooking chamber.
.
Clean outside of the appliance.
.
Clean the cooking chamber.
D
If a heating process is not possible after transport in cold environments: The safety temperature limiter
cuts off at freezing temperatures. Once the safety temperature limiter has been sufficiently warmed
again from the room temperature, it activates itself automatically.
.
Before initial commissioning or after extended operating breaks, fill approx. 5 litres of water into the
cooking compartment drain (overheating protection/(odour trap).
Only for appliances with automatic cleaning system, not for Types 2011:
.
Before initial commissioning or after extended operating breaks, fill approx. 5 litres of water into the
cooking chamber drain (overheating protection/odour trap).
D
If no water is filled (fault number 4003), this results in destruction of the pumps in the drain system!
Description of cleaning process, see chapter in the operating instructions:
−
Connection of the cleaning- and rinse-aid canisters for automatic cleaning (optional)
−
Cleaning the appliance and the cooking chamber
Gas appliances
Check gas pressures before initial commissioning of gas appliance, see page 22 chapter 8.7.2
Adjusting screen sensitivity, calibrating/aligning the display field
The screen sensitivity adjustment function is used to set sensitivity to touch.
During the calibration process, key assignments are reset/realigned on the screen.
.
1.) Carry out screen sensitivity adjustment (Touch Auto Zero).
.
2.) Carry out calibration process (Calibrate Touch).
The processes for sensitivity adjustment and calibrating the screen can be found in the operating instruc
tions.
Summary of Contents for Cucina Evo Easy Series
Page 27: ...27 28 ...
