Sam Cook Masterchef Line Executive PSC-WG-1020AA/B, User Manual

EN

TROUBLESHOOTING 

 --------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------

Caution! Before troubleshooting, disconnect 
the power supply. Only a qualified electrician 

of competent person must do the trouble

-

shooting that is not in this manual.

Important! There are some sounds during nor

-

mal use (compressor, refrigerant circulation).

Problem

Possible cause

Solution

Appliance dose not work

1.  Mains plug is not plugged in or is loose

2.  Fuse has blown or is defective 

3.  Socket is defective

1.  Insert mains plug.

2.  Check fuse, replace if necessary.

3.  Mains malfunctions are to be corrected by an electrician.

The food is not frozen 

enough.

1.  Temperature is not properly adjusted.  

2.  Door was open for an extended period.  

3.  A large quantity of warm food was placed in the 

appliance within the last 24 hours.  

4.  The appliance is near a heat source.

1.  Please look in the initial Temperature Setting section.  

2.  Open the door only as long as necessary.  

3.  Turn the temperature regulation to a colder setting temporarily.  

4.  Please look in the installation location section.

Appliance freezes or cools 

too much

1.  Temperature is set too cold or the appliance runs at 

SUPER modes.

1.  Turn the temperature regulator to a warmer setting temporarily.

Unusual noises

1.  Appliance is not level.  

2.  The appliance is touching the wall or other objects.  

3.  A component, e.g. a pipe, on the rear of the appliance is 

touching another part of the appliance or the wall.

1.  Re-adjust the feet.  

2.  Move the appliance slightly.  

3.  If necessary, carefully bend the component out of the way.

Water on the floor

1.  Water drain hole is blocked.

1.  See the Cleaning and Care section.

If the malfunction shows again, contact the Service Center.

CAUTION! MPM agd S.A. may change the technical features of the product without notice.

30

30