AIS 3410, Electronics Unit
ED3047G842 / 01 (2009-08)
Technical Manual
5 Setting-to-Work/Configuration
5.1 Setting-to-Work
t_ue_e05.fm / 27.08.09
45
5
Setting-to-Work/Configuration
5.1
Setting-to-Work
1.
The AIS Electronics Unit and the antennas must be installed as described in
). For information about the dimensions see
).
2.
The cabling and connection must be performed corresponding to the Cabling Documents in
3.
Depending on the system in which the AIS has to be integrated, the configuration has to be
performed as described in
.
5.2
Software Versions
The software versions can be downloaded as packages with the software components for all units of the
AIS system. For further information about the download and the update see
5.3
Configuration
No adjustments have to be performed on the antennas. These components are ready for use.
The AIS Electronics Unit must be parameterized via a connected RADARPILOT 1000/1100, CHART-
PILOT 9320/30, MULTIPILOT 1000/1100.
For information in detail, see the corresponding Technical Manuals and the Online Help of these systems.
The following descriptions are an aid for the configuration of the AIS.
NOTE:
Valid for NACOS xx-3 Systems only:
The AIS Electronics Unit is connected to the Ship’s Interface. The output interfaces of the
Ship’s Interface must be configured as follows:
-
Select "IEC 61162-1 edition 2/2000 (NMEA 2.3)" as driver
-
Set a repetition interval of
1 s
for the following telegrams:
-
GLL
-
VTG
-
HDT
-
ROT
-
VBW (if bottom-track log is available)
NOTE:
The system from which the AIS Electronics Unit has been configured and the AIS itself must be restarted
after any change in the configuration. Otherwise modifications may have no effect.
5.3.1 Configuration with RADARPILOT/CHARTRADAR/MULTIPILOT 1000/1100 - NACOS xx-4/5 Systems
It is necessary to configure the radar and the interfaces. For information in detail see the Technical
Manual of the RADARPILOT/CHARTRADAR 1000/1100 and MULTIPILOT 1000/1100.
