Sam4S ER230 Series Electronic Cash Register AU
Getting Started
•
11
Memory Clear
Memory All Clear (RAM Clear)
CAUTION: The procedures described in this area are security sensitive. Clearing all or parts of
the ER-230 memory may cause damage or loss to the program. Do not share this
information with unauthorized users.
Perform
"Clear All Totals"
, or
"Clear PLU File"
if you wish to clear only parts of
ER-230 Series
memory. Complete clearing of all memory areas and installation of the default program can be done
through the following special procedure:
To Perform a Memory All Clear (reset memory completely):
1.
Turn the power switch located on the right side of the register to the
OFF
position.
2.
Press and hold the key position where the
CHECK
key is located on the default
keyboard layout.
3.
Continue to hold the
CHECK
key while turning the power switch to the
ON
position.
4.
After hear BEEP, release
CHECK
key, “
ALL CLEAr
” will appear on the display.
5.
Press the
upper left key
(RECEIPT FEED) of the keyboard, then the
lower left key
(CANCEL), then the
upper right key
(MODE), and finally press the
lower right key
(CASH). “
g”-”O”-”O”-”d
” will appear on the display as you press each key one by one.
CHECK
2
CONV1
10
6
CHG 2
1
CHG1
9
5
3
11
7
SBTL
MODE
#/NS
CLERK
PO
RA
4
12
8
CASH
6
ERROR
CORR
5
4
-%
9
VOID
8
7
+%
RETURN
1
MACRO1
X/TIME
RECEIP
T FEED
PLU
CLEAR
-
CANCEL
0
SCALE
2
.
3
00
6.
Display will show “
= = = = = = = = = = = =
” while proceeding.
7.
When memory is cleared, the register prints a message
“RAM ALL CLEAR OK!”
