SPS-2000 Program Manual v1.30
Introduction
17
Passwords
The correct password is required to access Report Mode, P-Mode and S-Mode. Also, manager controlled
activities can be completed only after the correct password is entered.
Password Notes
Default S-Mode and P-Mode Passwords are:
2000
; the default Report Mode password is:
0000
(meaning
no password entry is required to access this mode); the default manager password is:
9999
. You can set
your own 4-digit passwords by selecting Passwords in
S
mode.
Separate passwords for report levels (X and Z1-Z5) can be set in S-Mode System Option #7. Here the
default password is also
0000
, meaning all report levels can be accessed without password entry.
Authority Level option #40 (found in P-Mode/Employee) allows access to Report Mode, P-Mode and S-
Mode without password entry. Employees (such as managers) linked to an authority level with this
option selected, can conveniently access all modes without password entry.
If an employee card system is used, and the MANAGER REQUIRED message displays, employees with
manager status can swipe their card to complete the transaction. (Available at version 2.00s)
Initialize
To Initialize the SPS-2000, turn the main power switch off, then on again.
Note: If you initialize while a transaction is in progress, the transaction will be aborted and totals/counters
will not be updated.
