Sam4s SPS-300 OP Manual v1.35
Service Mode Programming • 125
NOTE: You must allocate at least one line of electronic journal (EJ) and at least one check
for each clerk allocated.
To increase the number of clerks from the default allocation, you must first increase the
number of checks to a value greater than or equal to the desired number of clerks.
Starting at the PLU’s field, enter the quantity of each memory field. Press
CASH
after each entry, and the cursor will move to the next field. Page 2 of Memory
Allocation will display after the # OF GROUP TOTALS field is set:
MEMORY ALLOCATION
TTL AVAIL : 1855488
TTL USED : 314865
# EJ LINES 1000
# CHECKS 10
Y=HARD/N=SOFT CHK N
# LINES/SFT CHK 50
Continue filling each field until complete. Press
CASH
after setting the last field, "#
LINES/SOFT CH". The screen will display "ARE YOU SURE ?". N (No) will
display as the default answer to the question. If you wish to implement the new
allocation you have entered, press the
YES/NO
key, and then press
CASH
.
The message "PLEASE WAIT . . . . " displays until the printer prints either:
"MEMORY ALLOCATION OK !" or "MEMORY ALLOCATION SIZE OVER" if
you attempt to allocate features requiring more memory than is available.
The SERVICE MODE menu screen displays when memory allocation programming
is completed.
Memory Allocation Specifications
Allocation Area
Default Value
Minimum Value
Maximum Value
# PLUS
2000
300
20,000
# LEVELS (1 – 5)
1
1
5
# CLERKS
10
1
99
# GRROUP
TOTALS
20
1
99
# EJ LINES
1000
1
50,000
# CHECKS
10
1
200
Y=HARD / N=SOFT
N
# LINES / SFT CHK
50
1
230
