214 • Program Mode Programming
Sam4s SPS-300 OP Manual v1.35
Enter the number of the menu position (there are eight functions listed on each
function look up menu) that you wish to edit, press
CASH
.
FUNC #1 MENU ASSIGN.
MENU NUMBER : 1
CURRENT ASSIGNMENT
CANCEL
ENTER NEW FUNC CODE,
PRESS CASH
0
Type the code for the function you wish to place on the function look up key menu,
press
CASH
. See "Function Key Codes" in the "Service Mode Programming"
chapter, or press
PAGE DOWN
to view a list of functions and codes.
Go to step 2 above and continue to program menu numbers for the function look up
key, or press
CLEAR
to return to the
PROGRAM MODE
menu.
Removing a Function from a Function Look Up Key
To eliminate a function from a function key, you can replace the key assignment on the function
Look Up key with the INACTIVE key code (#445). Remove functions from the bottom of the
list up, i.e. first remove the function at position #8, then #7, etc.
Beginning at firmware version 1.071, the inactive code is listed when you press PAGE DOWN
or PAGE UP to select a function from the list. (Press PAGE UP to view the end of the function
list where the INACTIVE function is located.) The INACTIVE code was not listed in previous
firmware versions, however it was possible to enter the code “445”.
