260 • Program Mode Programming
Sam4s SPS-300 OP Manual v1.35
Machine No.
The machine number is printed on the register receipt. Program a machine number so that any
receipt can be identified with the store or register where the transaction took place. The machine
number may be a different number than the IRC register number programmed in IRC
programming (see "IRC Options" in the "Service Mode Programming" chapter.)
From the
PGM
control lock position menu, press
00
for
MORE
. The
PROGRAM
MODE
page 2 screen displays. Press
PAGE DOWN
to view the remainder of the
page 2 program options.
From the
PROGRAM MODE
page 2 screen, press
7
for
MACHINE NO
. The
MACHINE # PROG
. screen displays:
MACHINE # PROGRAM
MACHINE # 0
Type the machine number, up to 5 digits, press
CASH
.
Training Mode Password
If you wish to use training mode, you must program a password that you will use to enter
training mode. The password may be up to 4 digits long, however, if you choose to use a
password less that for digits, you must enter preceding zeros to complete a 4-digit entry. For
example, if you program the password to be "77", you must type "0077" when entering training.
From the
PGM
control lock position menu, press
00
for
MORE
. The
PROGRAM
MODE
page 2 screen displays. Press
PAGE DOWN
to view the remainder of the
page 2 program options.
From the
PROGRAM MODE
page 2 screen, press
9
for
TRAINING MODE P/W
.
The
TRAINING MODE P/W
screen displays:
TRAINING MODE PASSWORD
PASSWORD : 0
Type the password, up to 4 digits, press
CASH
.
