◀ 4 - 11 ▶
Remove bracket from the hard disk drive as shown in the figure.
5.
Remove screws from the hard disk drive as shown in the figure.
6.
Assemble it in the opposite way of dismantling and connect peripheral cables & DC power input jack.
7.
Press power button and check BIOS setup menu (appendix A)
to make sure the hard disk drive in correctly connected.
8.
Check the hard drive type before replacing. The 2.5 inch SATA interface is the only interface supported.
PART 4. System Expansion
04. HDD Replacement
HOME LIST HELP PRINT END
?
e-Manual
SPT-3700
System Introduction
System Installation
System Utilization
System Expansion
System Disassembly
System Reassemble
Upgrading Memory Module
HDD Replacement
MSR Removal
Internal Speaker Removal
Touch MSR Board Removal
LED Board Removal
LPT Board Removal
Joint Harness Removal
I/O Extension Board Removal
Main Board Removal
Touch Panel Removal
LCD Panel Removal
Appendix A
BIOS Set up
Appendix B
System Configuration