03. Connecting Peripherals
System Installation
◀ 2 - 9 ▶
Receipt Printer
Install & Test
–
Self-Test
SELF TEST PRINTING.
PLEASE PRESS PAPER FEED BUTTON
** End Self-Test **
1. Check whether the paper is properly inserted.
2. Turn the power off.
3. Pressing the Feed Button, turn the power on and then Self-Test begins.
4. It prints current firmware version and printer status.
5. After printing current printer status, it stops after printing the below sentence.
(Status-showing LED will continuously blink.)
6. To continue printing, press Paper Feed Button.
7. Self-Test automatically ends and cut the paper off after printing following message.
Self-Test Mode
Self-Test can check products for defects or disorder.
The procedure for Self-Test is as follows.
Printer Power
Status LED
Feed Button
HOME Contents Help Print Exit
?
Introduction
System Installation
Make sure of
installation area
Before connecting
peripherals
Connecting Peripherals
Connecting Serial Port Devices
such as Barcode Scanner
Connecting RJ-11 Cash Drawer
Connecting RJ-45 LAN Cable
Connecting USB Device
Connecting PS Module
Connecting Security
/ Scanner Module
Connecting Receipt Printer
Receipt Printer
Dismantle the Cover
for Customer Displays
Connecting DVR Card
Connecting AC Power
Cord to the Set Plug
Cable Management
System On / Off
System Use
System Expansion
& Dismantle
Appendix A
System Set-Up
Appendix B
System Structure
▶
▶
▶
▼
SPT-7000