Operator's manual
Two-rotor in-line rake
DUO 680
DUO 740
- 8 -
4.2. Transport
The lifting, handling and transporting operations can be very dangerous unless they are
carried out with the utmost caution. Have all persons not involved in the actual work move away
from the area and limit the zone where the operations are to be carried out. Also make sure that the
area in which the operations take place is clear and that there is a sufficient escape route, i.e. a free,
safe zone to which the operators can quickly move if the load should fall.
The safety hooks and ropes used to lift the machine must be of an adequate carrying capacity
To minimize the risk of serious injury or death, do the following:
When the machine is converted from the transport position to the working position and vice
versa, you could be pinched or crushed by some of its parts. Take extra care when carrying out
these maneuvers and have all persons keep well clear of the danger zone.
Do not change position of the rake until there are no people or animals around (pay particular
attention to children).
While transporting the rake, put a warning plate with combined lights and reflectors and
warning triangle on the rake.
During transport, always put the rake in its proper and safe transport position. See section 5.3.
Before putting the rake in transport position, make sure that the tractor’s PTO is turned off and
all rotating parts have come to a complete stop.
Do not drive over 25 km/h (15 mph). Drive slower if road conditions are poor, especially on
irregular surfaces or steep slopes.
The behavior of the tractor on the road, such as its turning and braking capacities, are affected
by the implements mounted.
When driving on the road after work, check to make sure that the tires and soil working tools
are clean to prevent the road surface from becoming dirty.
Make sure that the machine is not damaged during transport.
4.2.1. Putting the rake onto another vehicle for transport
The driver and the carrier are responsible for the rake’s transport safety. Equipment and parts
must be secured during transport. To put the rake onto another vehicle in a safe way, please obey
the following rules.
Transport should be done by qualified and specifically trained personnel,
Grab the rake by any lifting devices only in places indicated by hook sign,
For rake lifting, use only lifting devices with hoisting capacity larger than rake’s weight
shown in data plate. This also applies to ropes and chains used for lifting,
Do not lift if transport belts, belt suspensions, ropes are damaged. Whenever damage to
these parts occurs, replace with new ones,
When mounting slings, chains, handles etc., always set the machine's center of gravity
properly,
To safely support the machine, use ropes of adequate length so that the angle between them
is no greater than 120°, and the angle between the strand and the vertical is no greater than
60°,
Lift the machine with the utmost caution and move it slowly,
No one should be within the range of action of the lifting equipment when any transporting
operations are being carried out,
Collapsible parts should be blocked in transport position,
When the rake is on the vehicle’s trailer, the machine should be secured against moving.
