Operator's manual
Two-rotor in-line rake
DUO 680
DUO 740
- 28 -
Double windrow option
Lower the rear swath guard by pulling it down,
Fig. 31.
Position of rear rotor in working position with double windrow option
Remove the rear rotor guard from the transport holder and mount it in working holder by
retracting it for a proper distance,
Lock it with the front rotor cotter,
Retract cylinder of the rear rotor to its maximum, so that the rotor is turned rightwards,
Drive the tractor until the rear rotor has been turned right to its maximum,
Set rear 3-point linkage links at such height
H
so that the front ground following wheel is on the
ground and on the front drawbar cylinder there is a clearance which enables the front ground
following function,
If need be (while keeping a constant hitch height on the tractor), adjust the clearance with knob
P
.
Fig. 32.
Setting front drawbar for operation
5.8.
Raking width adjustment
DUO
in-line rake has smooth adjustment of raking width ranging from 11' 2" (12' 10" DUO
740) up to 22' 4" (24' 3" DUO 740) by means of a double-side cylinder for adjusting the position of
the rake's rear working assembly. Bear in mind, that the maximum raking width for the single-row
option is the difference of 22' 4" reduced by overlapping
Z
(
Fig. 30
) value for rear and front rotor's
tracks.
H
P
