Operator's manual
Trailed disc mowers
KDC 300 S/W; KDC 340 S/W
KDC 300 ST/WT; KDC 340 ST/WT
- 30 -
1. In order to clean roller switch lever D when rotating belt to 1 and hold down until bulges
disappear (Fig. 25). This should also be performed from the other side of conveyor if necessary.
Fig. 25. Cleaning conveyor rollers.
2. Impurities inside belt are removed once conveyor is in vertical position. Belt is deflected with
hand and then impurities are removed with a hook wire.
Fig. 26. Removing impurities from inside belt
6.8.2.
Conveyor belt replacement and adjustment instruction
KDC 300-340 S/W mower with conveyors must be mounted on a tractor.
I.
Steps to be taken when transporting in operating position (horizontal).
1.
Using a marker, mark lines on millimeter measures – decal N-79 (unless belts worked well).
2.
Loosen tightening mechanism of tightening roller belt – bolts M10 - S
1
, nuts
M12 – N
2
and unscrew adjustment bolt M12 – S
2
by approx. 30 mm (Fig. 27).
1
bulges
1
D
