Operator’s manual
Double-sided mower with central
suspension
“REWERS”
- 24 -
1.
Control on/ off switch
11
.
Disabled button
2.
Time display
12.
Disabled button
3.
Control emergency stop –
13.
Disabled button
restart of the control will follow after F1
14.
Transport position
(
19
) and F2 (
18
) buttons are pressed
15.
Pressure modification in unloading system
at the same time.
16.
Right cutterbar locking
4.
Information screen
17.
Left cutterbar locking
5.
Disabled button
18.
Function button F2 to cancel emergency mode
6.
Disabled button
19.
Function button F1 to cancel emergency mode
7.
Disabled button
20.
The menu
8.
Lifting to headlands of left cutting unit
21.
Menu navigation button
9.
Working position
22.
Menu navigation button
10.
Lifting to headlands of right cutting unit
23.
Information diode
Fig. 22.
Steering box
5.3.1. Setting mower in transport position on headlands
In order to set the mower in transport position on headlands push button (
1
)
and (
9
)
on control panel (
Fig. 21
).
In order to use one of the cutting units, e.g. right one, lift both of them to transport position on
headlands using button (
9
)
while using the lever to control the tractor's external hydraulics and
lock the left one against falling with button (
8
)
. Right cutterbar is protected against falling with
button (
10
)
.
Protection of the chosen cutterbar is signalled with a red diode located over the button which
corresponds to the cutterbar. In order to unlock particular cutterbar push either of buttons (
8
)
or
(
10
)
again – unlocking cutterbar protection is then signalled by dimming of the red diode.
5.3.2.
Setting mower in vertical transport position
In order to set the mower in vertical transport position (
Fig. 25
) press button (
14
)
while
using the lever to control the tractor's external hydraulics.
If near the end of lifting phase the
cutterbars are stopped and mechanical protection devices are not locked then increase pressure in
unloading system. To perform this push button (
14
)
again (disabling is then signalled by
dimming of the green diode), push button (
15
)
and continue setting the mower in transport
position until mechanical protection is locked. Next disable control with button (
1
)
.
Placement of RS cable to steering
panel
Switch ON/ OFF of steering panel’s
power
