Operator’s manual
Double-sided mower with central
suspension
“REWERS”
- 25 -
To lift only one cutterbar, e.g. the right one for any height just push button (
16
)
, and to
lift the left one only push button (
17
)
. The lifted units can be locked in their current positions
by pressing the buttons for lifting twice.
5.3.3.
Changing language version of control panel
On the control panel, it is possible to change language version for descriptions of the displayed
options. In order to change, press button
MENU
(
20
)
. Navigation through the option list is
performed by means of buttons (
9
)
and (
20
)
. To confirm your choice, use button (
21
)
.
Press button (
22
)
to leave the options menu.
5.3.4.
Service mode
When service mode is selected from the control panel, it is possible to check the mower's serial
number and work time, i.e. machine's man-hour time. To run service mode, turn off the panel, and
press buttons (
1
)
and (
2
)
at the same time until information is displayed on the information
screen (
4
). To exit the service mode, turn off the panel and on again with power switch (
Fig. 22
).
5.4.
Preparing the mower for transport – version without controller
To prepare the mower for transport and to meet safety precautions, please do the following:
lift the mower with a hydraulic lift, so that the tractor's lower links are about 30 cm from the
ground (
Fig. 25
),
lift support feet
S
and secure them with cotter (
Fig. 23
),
Fig. 23.
Support feet
fold side safety curtain to reduce the total transport height,
Using hydraulic cylinders lift the cutting unit to a vertical position, so as to close the pawl
Z
(
Fig. 16a
) and transport locks shown in
Fig. 24
.
CAUTION:
Failure to close the transport lock (
Fig. 24b
) will damage spline shafts.
S
