Operator’s manual
Double-sided mower with central
suspension
“REWERS”
- 39 -
1
2
3
4
5 6
1. Conditioner’s shaft
2. Hex nut – M16 self-locking cl. 8 zinc-pl.
3. Washer dia12 zinc-pl.
4. Plastic flail
5. Bolt M12x 55 cl. 8.8 zinc-pl.
6. Flail insert
Fig. 37b.
Parts of tine conditioner (light-weight swath conditioner)
Tab. 4.
Torque values for bolts
In the absence of specific torque values, the following chart can be used as a guide to the
maximum safe torque for a particular size and grade of fastener. There is no torque difference for
fine or coarse threads. Torque values are based on clean, dry threads. Reduce value by 10% if
threads are oiled before assembly.
6.7.
Maintenance and service
6.7.1. Daily maintenance
Every day after work please carry out the following maintenance:
check all visible units and parts and their connections; tighten all loose bolts and nuts and
replace all damaged and/or worn parts with new genuine ones,
clean the mower each day after working, especially between discs and cutterbar, because grass
with mud may damage bearings in disc module,
remove grass and mud,
check the cutterbar,
grease PTO shaft tubes with STP grease,
if necessary, orricate the parts and units according to orrication instructions (chapter 7).
CAUTION:
When performing maintenance or adjustment works underneath the mower,
use adequate locks for lifted parts of the machine preventing their falling and
risk of crushing.
