12
KDT
REAR DISC MOWER
OPERATOR’S MANUAL
IMPORTANT:
Maintenance and adjustment should ONLY be done after the following has occurred:
❑
tractor’s engine has been
stopped and ignition key has been taken out,
❑
all rotating parts have come to complete standstill (NOTE: cutting knives will rotate for
several minutes after engine is turned off),
❑
the cutterbar is on the ground, and
❑
Never tamper with or remove safety devices on the machine or make them inoperable.
❑
Before starting work and periodically thereafter, replace any damaged, missing and/or worn knives
and knife holders.
❑
When driving on public roads always comply with local traffic regulations, especially those
concerning warning lights.
❑
When the mower is lifted for repair on 3-point linkage, it should be secured against falling by
mechanical support or by chain.
❑
The bolts and other fasteners have to be periodically checked and, if necessary, tightened or
replaced. DO NOT work with damaged or worn fasteners.
❑
Never lift the mower on tractor linkage when the drive is operating and the cutting discs are rotating.
❑
When operating the mower, the tractor should always be equipped with operator protection that is
required by laws and regulations.
❑
Never start the mower when the mower blades are off the ground.
❑
Before you start the tractor make sure that all drives are turned off and the levers that turn the
hydraulics are in neutral position.
❑
Never leave
tractor’s engine running without supervision. Before you leave the tractor, turn off the
engine and remove the key from tractor’s ignition.
❑
DO NOT operate the mower when driving the tractor backwards.
❑
Permissible inclination of the mower on a slope when w
orking and during transport is 8°. Exceeding
this incline can result in mower tipover.
❑
Never stand between tractor and mower unless tractor and mower are secured against moving by
the tractor’s brake.
❑
If any maintenance must be done under an elevated mower, it must be blocked or otherwise secured
against falling.
❑
When the parts of the mower need replacement, use only original spare parts as described in the
spare parts list. Pay particular attention to PTO shaft’s guards and mower’s and tractor’s spline
shaft guards.
❑
Hydraulic hoses are potentially very dangerous. Do the following to minimize any hazards:
❑
Hydraulic hoses should be periodically checked and if any damage to the hoses have
occurred or if they have been used more than 5 years, replace with new ones.
❑
Never use scotch tape to repair hydraulic hoses.
❑
When connecting hydraulic hoses to tractor’s hydraulic connectors, make sure that the
tractor’s or mower’s hydraulic system is not under pressure.
❑
The mower should be stored under a roof and in a way as to not be hazardous bot people or animals.
❑
In the event of an accident involving this mower in a field or on a road, follow all applicable first aid
procedures and contact SaMASZ technical service.
❑
Mower should be kept clean, so as to avoid danger of fire.
❑
No person and no objects must remain on the mower when driving or transporting.
