37
OPERATOR’S MANUAL
REAR DISC MOWER
KDT
1
2
3
4
Fig. 31.
Adjusting tine conditioner’s mask
6.9.
Replacing the conditioner’s tines
(Models:
KDT 220 S and KDT 260 S(SL)
)
Prior to commencing any operation, check condition of bolts on which flails are set, as well as condition
of fails themselves. If flails or bolts are worn or damaed, it is necessary to replace them.
Bear in mind, that flails should be replaced in pairs (opposite) featuring the same weight in order to
keep shaft well balanced.
Not keeping the shaft well balanced may lead to premature wearing of
bearings as well as the shaft itself.
Replacement of flails
3
consists in unscrewing of nuts
2
, removing bolts
4
and mounting brand new
flails
3
NOTICE:
In order to tighten screw connection use special purpose bolt M16x60 z. Property
Class 10.9 and self-protected nut M16 z. Property Class 8.8;
torque down until tight.
1. Scarfier shaft
2. Self-locking nut M16 z. Property Class 8.8
3. Flail
4. Bolt M16x60 kl. 10.9
Fig. 32a.
Parts of tine conditioner
+
-
