Operating manual
Rear disc mowers with central suspension
- with hydro-pneumatic or spring suspension
- 3 4 -
using the upper regulated tie G (Fig. 9) adjust to the required cutting height. Extending the tie
G increases cutting height and shortening it decreases it,
depending on the tractor used the mower should be connected to the three-point hitch so that
the distance Y, the distance between the interior cutting disc and the tires of the tractor, is from
0 to 10 cm with KT 260 (H) and KT 261 (H). With KT 300 H and KT 301 (H) the distance Y
should be from 30 to 40 cm and with KT 340 (H) and KT 341 (H) from 50 to 60 cm.
Fig. 16. Side positioning of the mower in relation to the tractor
6.
ASSEMBLY AND SETTINGS
6.1.
Installing the cutting blades
The cutting blades should be installed The blades should be installed according to
the schematic shown in
Fig. 17
. The blades recommended by the manufacturer have the dimensions
115x49x4 and fulfill the requirements of the norm PN-EN 795:2002. Cutting blades should be
installed observing the rule that the blade after cutting the grass should push it upwards (the cutting
edge must be lower).
Fig. 17. Cutting blade installation schematic
ATTENTION:
Use only blades with the SAMASZ logo.
CAUTION:
Condition of knives should be checked each time before commencing any
operation.
Y
With KT 260 (H)
KT 261 (H)
Y = from 0 to 10 cm
With KT 300 (H)
KT 301 (H)
Y = from 30 to 40 cm
With KT 340 (H)
KT 341 (H
Y = from 50 to 60 cm
Right blade
Left blade
Right rotation
Left rotation
