24
KWT, CAMEL, KOLIBER, KW, LAMA
REAR EXTENSION ARMS
OPERATOR’S MANUAL
4.
SAFETY PRECAUTIONS
4.1.
Safety rules and regulations
❑
Front axis of the tractor should be balanced to enable its steering. If necessary, use front wheel
weights.
❑
In order to keep steering conditions, make sure that impact on the front axis is at least 20% of
the complete impact on the tractor.
❑
The machine cannot be used if the tractor has not been properly balanced.
❑
Any operation with the hydraulic lift lever should be done from the operator's seat; never operate
the lever from outside of the tractor.
❑
For tractors equipped with EHR, control with hydraulic lift is done with a button located outside the
tractor's cabin. When operating, please exercise particular caution.
❑
When mounting the machine on a tractor, risk of wounding is likely. It is recommended that operator
wears protective gloves.
❑
Use PTO shaft with CE marking.
❑
Do not operate without safety guards. Neither operation with damaged nor raised guard is allowed
(risk of stones, etc. being thrown out). Damaged safety curtain should be replaced.
❑
Start mowing only when the tractor PTO reaches its nominal 540 rpm value or 1000 rpm
–
depending
on the type of machine (See section 3.1).
❑
DO NOT exceed 600 PTO rpm or 1050 rpm (See section 3.1).
❑
Please make sure that no unauthorized personnel remains within the danger area of at least 164 ft
(50m). Keep particular caution when operating near roads and in stony areas.
❑
Perform any maintenance and adjustment work only when the drive is disconnected and rotor has
stopped completely.
❑
When driving on public roads always comply with local traffic regulations, especially on the warning
lights.
CAUTION!
Make sure to perform any service and repair operations with the tractor drive
shut off and after all rotating parts have stopped completely!
WARNING!
Keep children away from the machine when operating and idle.
❑
Check bolts and other fasteners regularly. Do not operate with damaged or worn fasteners.
❑
Condition of flail knife mounting and bolts should be checked regularly (loose bolts and worn
openings in the mounting brackets). Damaged or worn knives must be replaced in pairs.
❑
Do not leave a running tractor without supervision. Before leaving the tractor turn off the engine and
remove the ignition key.
❑
If any break in the machine operation occurs, turn off the drive
❑
Tractor cooperating with the machine should be equipped with a driver's cabin.
❑
Machine should not be operated when the tractor-machine aggregate is not well balanced.
❑
Never start the machine if any people or animals are around the machine.
❑
Always follow safety labels describing hazards, and warning signs placed on the machine.
❑
Before starting the tractor make sure that each drive is disconnected and control levers for
hydraulics are in neutral position.
❑
Do not drive the machine backwards when operating.
❑
Never get onto the machine.
