26
KWT, CAMEL, KOLIBER, KW, LAMA
REAR EXTENSION ARMS
OPERATOR’S MANUAL
4.2.
Operator's qualifications
To provide safe machine operation each person being the machine operator must meet the
following requirements:
❑
Operator should hold driving license, have ability to drive vehicles safely and know road traffic rules.
❑
Operator must be in proper physical condition to be able to operate the machine.
❑
Operator must not be under the influence of alcohol, drugs and medicines, which all have influence
on vehicle driving and machine operation.
❑
Operator should be familiarized with this manual and follow its provisions.
❑
Operator should be familiar with working principles of both the tractor and the machine, and be able
to recognize and avoid hazards resulting from operation of the aggregate
.
4.3.
Conditions of mounting machine on tractor
❑
Before attachment, be sure that the tractor and machine hitches are compatible and that the
tractor's hitch load capacity is adequate for the machine which is to be mounted or attached.
❑
Before mounting the machine, examine the technical condition of the machine's hitch assembly
and tractor's 3-point linkage.
❑
Use only genuine cotter pins to mount the machine on a tractor.
4.4.
Transport
❑
Any change in the machine's position are only possible when no unauthorized personnel is around
(children in particular).
❑
When transported the machine should always be set in transport position. (see chapter 5.2).
❑
Prior to putting the machine to transport position make sure, that the tractor PTO is disconnected
and all the rotating parts in complete standstill.
❑
Always adjust your driving speed to the current road conditions and according to local traffic rules.
❑
Permissible speed of 25 km/h cannot be exceeded.
❑
Allow no person and object to remain on the machine when driving or transporting.
❑
When taking turns pay particular attention and consider the machine's weight and dimensions.
4.4.1.
Putting the machine onto another vehicle for transport
Both the carrier and the driver shall be responsible for the machine transport safety. Any
equipment and parts must be properly secured for transport. To put the machine onto another vehicle
safely, please follow these rules:
❑
it is recommended to transport extension arms using a forklift truck (
❑
the machine should be seized by any lifting device only in places indicated on the machine by
the catch sign (
❑
for lifting the machine, lifting devices with hoisting capacity bigger than the machine weight shown
in data plate should only be used. It also concerns ropes and chains used for lifting,
❑
transport belts, belt suspensions, ropes cannot be damaged. Whenever damages to these parts
are spotted replace these with new ones,
❑
when mounting slings, chains, handles etc. always pay attention to setting the machine's centre of
gravity properly,
❑
to catch machines, pick ropes of adequate length, so that the angle between them is no greater
than 120°, and the angle between the strand and the vertical is no greater than 60°,
