Operator's manual
Arm
Flail head
- 41 -
2.
Control switch off. To turn control off, hold button (2) for around 2 seconds. Turning control on
is signaled by a diode (3), which turns to steady light.
3.
Diode signals turning both power and control on.
4.
Safety breakaway device.
5.
Button for switching to mowing head's right-hand gears and diode signaling turning the head on.
To turn the head on, press and hold button (3) for around 2 seconds. In order to turn the head off
push button (5) or (6) until the diode goes out.
6.
Button for switching to mowing head’s left-hand gears and diode signaling turning the head on.
Left-hand gears are turned on, whenever wire or flexible, thick branches get wound up onto the
flail shaft.
Turning left-hand gears on:
a)
If right-hand turns are engaged, turn them off, release the button and wait for 3 seconds (in
this period the buttons are inactive) and then push button (6). In order to turn left-hand
gears off hold button (6) or (5) again until the diode above the button goes out.
NOTE: Once the head rears are off buttons (5) and (6) become inactive for 3 seconds.
7.
Button for turning arm’s floating function and diode for signaling the floating function. To turn
arm’s floating function press button (7). To turn the function off just hold the button (7) again.
8.
Diode for signaling turning the mowing head’s floating function on. Turning the head’s floating
function on/off is performed by means of button (3) found on joystick (Fig. 46).
9.
Diode signaling if the first arm’s unloading function is on. Turning the unloading function on/off
is performed by means of joystick’s button (4).
10.
Diode for signaling, if admissible oil temperature is exceeded.
Caution! If oil temperature is exceeded, turn the working head off. If oil temperature does not get
lower within 10 minutes, control would be turned off. Control will be turned on again when oil
temperature gets lower. Diode for signaling low oil level.
11.
Diode for signalling low oil level.
Joystick and its functions
Fig. 46. Control joystick overview and description of its functions - KWT 550E/650E/651E, Camel 900 E,
Koliber EP
1 – Button 1 and pictogram 1 to symbolize the button.
2 – Button 2 and pictogram 2 to symbolize the button.
3 – Button for turning on the head's floating function. Pushing the button turns on the head’s
floating function, which is signaled with lighting up of diode (8) on control panel (Fig. 45).
Pushing button 3 on joystick again turns off the head's floating function. The floating function
gets turned off also when the head’s rotation is being controlled.
4 – Button for turning on the head's unloading function. Pushing the button turns on the first arm’s
unloading function, which is signaled by lighting up of diode (9) (Fig. 45). Pushing button 4 on
joystick again turns off the head's unloading function.
3
4
1 2
