Operator's manual
Arm
Flail head
- 58 -
9.
REPAIR AND WITHDRAWAL FROM USE
Prior to any repair works, potentially related to admitting it for use, the machine should be
cleaned thoroughly and any grass, dirt or mud removed.
Carefully check nuts and bolts for adequate torque and the pins for wear. If it is found, that after
replacement of some worn parts the machine is able to operate, then damaged parts are to be replaced
with new ones. Fitting elements (bolts, nuts, shaft pins, etc.) should also be replaced.
If the machine cannot be repaired anymore (its repair is impossible), it should be withdrawn
from use. In such case, oil should be drained (to special tight containers) from intersecting axis
gearbox and taken to used oil and grease treatment plant. Thoroughly clean remains with cleaning
agent, take plastic elements off. These should be used further on or delivered to a proper waste
treatment company. Remaining metal parts should be sold to breaker's yard.
When dismounting the set and particularly during disconnection of assemblies and parts,
keep all safety precautions. Dismounting works should be performed in protective gloves.
Withdrawal of dismounted parts should conform with natural environment protection
requirements.
