Operator's manual
DITCH CLEANER
OR 080 (L)
-
12
-
5.
OPERATING
5.1
Attaching the ditch cleaner to the extension arm
In order to mount ditch cleaner on extension arm perform the following while keeping the
sequence:
place pallet with ditch cleaner on even and paved ground,
drive tractor with mounted extension arm on and set the arm’s mounting plate, so it overlaps
with ditch cleaner’s mounting plate,
protect tractor against moving with use of parking brake,
mount the cleaner’s mounting plate on the arm’s mounting plate with 6 bolts and nuts M14,
connect hydraulic hoses with use of push-in fittings while paying particular attention to
connecting the cleaner’s supplying hose to supply connector P(+) of the extension arm and the
cleaner’s return hose to return connector T(-) of the extension arm (
Fig. 4
),
lift up ditch cleaner, which is connected this way slightly above the ground and examine all bolt
connections and check whether there are no vivid damages,
pre-start ditch cleaner in order to check whether connections and operation are correct.
Fig. 4.
Markings of hydraulic hoses
CAUTION:
When connecting and inspecting the machine, respect any safety conditions
provided herein.
5.2
Transport position and drive
Transport position of ditch cleaner aggregated with SaMASZ extension arm corresponds to
the arm's transport position. See
Fig. 5
.
In case of mounting ditch cleaner on other type of extension arm, put the machine aggregated
with the arm in the compact most position.
•
Use any transport protective means as provided for controlling and design of extension arm to
transport the aggregation of extension arm and ditch cleaner.
•
For transportation purposes disconnect PTO. Bear in mind the proper marking and lighting of the
aggregated machines as a low-speed vehicle to comply with road traffic provisions.
•
Driving speed should always be adjusted to current road conditions.
•
Transport speed on public roads cannot exceed the mean speed of 25 km/h.
Rotation