Operator's manual
DITCH CLEANER
OR 080 (L)
-
15
-
5.3.6
Proceedings in case of machine locking
Perform any works at the machine only with drive off and no pressure in hydraulic assembly.
Take ignition key off and protect vehicle against uncontrolled motion or starting.
Put protective gloves on and remove the part, which causes the machine locking.
Lower adaptor onto the ground.
5.3.7
Dismounting machine from the extension arm
To dismount the machine from the extension arm:
turn cutterbar’s drive off,
drive the tractor with connected the extension arm and the ditch cleaner to the pallet. The pallet
must be placed on the equal and hardened ground,
carefully put a ditch cleaner on a pallet,
secure the tractor against its free runaway,
turn the tractor's engine off and take ignition key off,
disconnect a hydraulic hoses,
disconnect ditch cleaner’s mounting plate from the extension arm’s mounting plate by
unscrewing,
carefully drive away with the tractor.
6.
MAINTENANCE AND SERVICE
CAUTION:
Use only genuine SaMASZ fittings and spare parts. Spare parts of unknown
origin or new made feature lower strength and have unfavourable influence on
machine’s overall performance and safety.
CAUTION:
The SaMASZ co. shall not bear any responsibility for damages and defects
caused as a result of applying non-genuine parts and fittings.
6.1
Daily maintenance
Prior to commencing operation with ditch cleaner perform the following:
make sure, that both the tractor and the extension arm, to which ditch cleaner is mounted, work
properly,
set adjustable guard,
set relevant depth by adjusting skid’s height (p. 5.3.3),
examine bolt connections of cutting disk, knives and if need be tighten these,
examine torque of all bolts and nuts according to
Tab. 2,
examine condition of hoses and hydraulic connections,
examine condition of cutting knives, and if need be, recover these or replace with new ones,
replace damaged parts with new ones.
After 4-5 hours of operation:
examine bolt connections, and particularly these found on cutting disk, knives and if need be
tighten them
(Tab. 2
),
examine condition of hoses and hydraulic connections,
examine whether cutting knives can be used again.
Once operation with the machine is complete, do as follows:
examine bolt connections, and particularly these found on cutting disk, knives and if need be
tighten them,
clean the machine thoroughly from any dirt and then wash and dry it.