Operator's manual
DITCH CLEANER
OR 080 (L)
-
18
-
8.
DISMOUNTING AND WITHDRAWAL FROM USE
8.1
Repair
In case of partial wearing of ditch cleaner, replace any worn parts. Prior to this, clean the
machine from dirt. If need be drain oil into a tight tank or protect connecting nozzles. Next replace
all worn parts and mount the cleaner back with new coupling, protecting and sealing parts. Bolts
should be screwed with torque corresponding to their strength classes.
CAUTION:
Before disassembly the ditch cleaner should be disconnected from the tractor.
Once the machine is repaired perform the following:
Make sure that all elements are installed properly,
Install the removed guards,
Check that all screws and nuts are tightened,
Once all the guards are installed, perform a warm-up start to make sure the repaired machine
operates properly.
8.2
Disassembly and scrapping
Pay particular attention when mounting and dismounting and use drawings provided in the
spare parts catalogue.
Store damaged or worn parts in a restricted area and then deliver them to a scrap yard
If the machine cannot be repaired any more, it should be withdrawn from use. Thus, clean the
machine from any dirt and chips. First, drain oil from the hydraulics and dispose of properly. Then
disassemble the whole ditch cleaner and remember to segregate parts according to the kind of
material used and deliver them to a scrap yard.
8.3
Environment
•
Ditch cleaner is a fully natural environment-friendly product.
•
90% of parts used in ditch cleaner are recyclable.
•
Materials used for packaging are 100% recyclable.
•
Worn machine parts and packaging should be utilized in conformity with local natural
environment protection regulations.
•
During whole operation period, pay attention to prevent any oil leak from hydraulic assembly,
which may cause environmental pollution.
