Operator's manual
DITCH CLEANER
OR 080 (L)
-
7
-
In case of a fatal failure, stop the machine's drive, turn the tractor's engine off and take out the
ignition key. Then call for technical service, and if an accident (in this case: road accident)
occurs, respect first aid rules and contact responsible authorities.
4.1.4
Inspection and repair
Perform any inspection, repair and maintenance works as well as cleaning parts or assemblies
with drive off and no pressure in hydraulic assembly, with ignition key off and the aggregation
in standstill position.
Bolts and other fasteners should be inspected on regular basis. Operating with damaged or worn
fasteners is not admissible.
Damaged or worn (aged 5 years or older) hydraulic hoses and other hydraulic parts should be
replaced with new ones as recommended by the Manufacturer.
Never repair damaged hydraulic hoses with tape.
When servicing hydraulic assembly, always wear protective gloves and eyewear. Hydraulic oil
leaking under pressure (20MPa) may permeate through the skin and cause its irritation
thereafter. If such is experienced, visit a doctor immediately.
DO NOT perform repair works underneath machine’s assemblies, which are lifted and
unprotected against free falling.
Examine condition of cutting knives before commencing any operation. In the event of finding
these blunt, hand them for recovery. Damaged or worn knives must be replaced with new ones
in pairs.
Use only genuine spare parts, which can be ordered at our store or at your dealer.
When operating, maintenance and regulation works are conducted always wear protective
gloves, footwear and clothing with no loose parts, belts, etc.. Always comply with safety decals
placed on the machine.
In the event of fatal failure, please call for technical service, and if an accident (in this case: road
accident) occurs, respect first aid rules and contact responsible authorities.
CAUTION:
Prior to maintenance and repair the machine, turn off the engine of tractor. All
rotating parts should be stopped.
4.1.5
Replacement of damaged or worn parts
Any works related to replacement of worn or damaged parts should be done only after the
machine has been switched off, and having previously learned the contents herein.
After the engine has been turned off and the ignition key removed, the vehicle should be
secured against any accidental movement.
When conducting repair works or replacing worn or damaged parts wear protective gloves,
protective footwear as well as protective clothing without any loose elements.
When operating with the machine lifted up, protect it properly with supports and when replacing
parts with sharp edges, use personal protective equipment and corresponding tools.
Once works related to replacement of defective parts are completed, mount back all elements of
guards and safety devices.
CAUTION:
During replacement of working parts, it should be used personal protective
gloves.
4.1.6
Storing
Ditch cleaner should be stored under roof and in manner which effectively prevents animals and
people from being injured.
