27
OPERATOR’S MANUAL
TRAILED ROTARY TEDDER
P10-1200
WARNING!
It is not recommend
ed to set a 14° tilting angle in the wheel systems
because
of the possibility of collision between the ground wheel and the working springs
in the transport position.
In order to make it easier for the operator to obtain the right tilt angle after levelling the machine, the
tedder has been equipped with a tilt cylinder lock (
). The rotatable lock is mounted on the cylinder
pin. It is possible to change the angle in the HORIZONTAL position (
).
In order to adjust the tilt angle it is necessary to:
❑
unlock the bolt,
❑
rotate the lock to the desired position (so that one of the longitudinal holes is aligned with the axis
of the cylinder),
❑
lock the bolt in the appropriate hole.
Fig. 23.
Setting the tilt working angle in the tedder system. a) horizontal position, b) working position
Blocking bolt
a)
b)
Position:
HORIZONTAL
Position:
INCLINED
