7
OPERATOR’S MANUAL
TRAILED ROTARY TEDDER
P10-1200
3.3.
Standard equipment and spare parts
The tedders are sold with the following standard equipment
:
❑
warranty card,
❑
operator’s manual with spar
e parts list and Declaration of Conformity,
❑
PTO shaft,
❑
slow travelling vehicle board,
❑
spray paint (150 ml).
Tab. 2.
Recommended PTO shafts for rotary tedders
Model
Power
Length
Moment
Symbol
Clutch
Manufacturer
KM
mm
Nm
P10-1200
21
1210-1733
270
8G5T085CE007001
friction
Bondioli & Pavesi
Fig. 4.
PTO shaft lubrication points
WARNING!
The frequency of lubrication of the articulated telescoping shaft should be
carefully adhered to. Points shown in
should be lubricated every 50 hours.
The articulated telescoping shaft should also be lubricated before and after
longer periods of disuse
.
PTO shafts of other brands with equivalent parameters could be used after SaMASZ permission.
4.
SAFETY ADVICE
4.1.
Safety rules and regulations
❑
Operation without safety guards as well as with the damaged guards is not allowed.
❑
Start tedding only when the tractor’s PTO reaches its nominal rpm
.
❑
Nobody is allowed to remain within the danger area of at least 50 m. Particular caution is necessary
when operating near roads and in stoney areas.
❑
Any maintenance and adjustment work should only be done after the drive has been disconnected
and the rotors are in standstill.
❑
When driving on public roads always comply with local traffic regulations, especially concerning
warning lights.
PTO shaft’s end without clutch
–
To be mounted on the
tractor’s side
PTO shaft’s end with
friction clutch
–
To be
mounted on tedder’s side
